Hose Protection Solutions

Hoses near headers, turbos and downpipes take a beating from radiant heat, and this collection covers the Vibrant Performance hose protection sleeving that keeps them alive. Heat Protect and ExtremeShield sleeves are rated from 1200 to 1400 degrees and sold by the foot in sizes to fit over common hose and hose ends.

What it protects

Sleeving shields fuel lines from vapor lock, oil lines from cooking, brake hoses from fade and coolant hoses from early failure. It also guards against abrasion where a hose passes a sharp edge.

Choosing a size

Measure the largest diameter the sleeve must pass over, usually the hose end, and choose a sleeve with a little room. Use the higher temperature rating for lines closest to the heat source.

Common questions

Should sleeving be installed before the hose ends? If it will not fit over the ends, yes. Slide it on before assembling the line.

How do I finish the ends? Use clamps or high temperature tape to keep the ends from fraying and sliding.

Does sleeving replace heat shields? It complements them. Use both where a line runs very close to the exhaust.

What's in This Collection

  • 30 products from Vibrant Performance, priced from $5.03 to $53.99
  • AN sizes: -8
  • Materials: Stainless
  • Finishes: Black
  • Free shipping on orders over $150

How to Choose

Match the inlet and outlet size to your exhaust tubing, then think about sound and space. Mufflers control overall volume, resonators knock down drone and rasp, flex sections absorb engine movement, and a good clamp or hanger keeps everything sealed and supported.

More Questions

What causes exhaust drone?

Drone usually shows up at highway cruising speed when the exhaust frequency matches the cabin. A resonator placed in the right spot is the most common fix.

Do I need a flex section?

On engines that move a lot on their mounts, especially turbo setups, a flex section near the engine helps prevent cracked welds and broken hangers.