45 Degree Aluminum Bend, 2.75" O.D. - Polished

Silicone couplers like this fabricators searching "2880/45" are looking for one specific piece: vibrant's 45 degree mandrel bend in 2.75 in. outside diameter, made from 6061 aluminum with a 16 gauge (1.5mm) wall. inlet and outlet are both 2.75 in. O.D., and each leg runs 6.000 in. straight past the bend, which gives you room to trim for fit or to slide on a coupler. mandrel bending keeps the tube round through the curve, so airflow isn't choked at the bend the way it can be in crush-bent tubing. are the standard way to join charge pipes and intake tubes on boosted and naturally aspirated builds. Made by Vibrant Performance, part number 2880.

Specifications

• Part Number: 2880
• Brand: Vibrant Performance

Install Notes

Bead the tube ends so the coupler cannot slip off under boost, and use T-bolt clamps on pressurized joints. Keep the coupler away from direct contact with exhaust parts, and leave a small gap between the pipe ends so the joint can flex with the engine.

Vibrant Performance has been building exhaust, intake and fluid plumbing parts for the performance aftermarket since 1997, and fabricators and race shops around the world use its parts.

Keep Shopping

• 45 Degree Aluminum Bends
• Aluminum Mandrel Bends & Straight Tubing

Fitment: Universal. Confirm the sizes and thread types listed above against your application before ordering.