A truck carpet project starts with the floor configuration. Before dismantling the cab, compare the replacement kit's application with the truck's year, cab style, transmission and floor layout. A modified truck may differ from the configuration described by its model year alone.
Record what is in the cab
Photograph the bench or bucket-seat arrangement, tunnel, shifter boots and rear cab corners. Include any aftermarket brackets or console. Label loose hardware by location as components come out. Follow the truck's service manual for seat removal, electrical precautions and reassembly requirements.
Keep the old carpet nearby throughout the work. Use it as a record of what was removed, while checking every planned opening against the truck itself. Previous owners may have enlarged holes or installed accessories that your replacement interior will not use.
Prepare the floor before fitting
Remove dirt and inspect beneath the old padding. Look closely at damp areas and places where insulation concealed the metal. Repair the cause of water entry before installing fresh material. If the project involves rust repair or altered seat mounts, complete that work before treating the carpet as ready for installation.
Decide on insulation before fitting the carpet. Keep a written note of where each layer belongs so you do not accidentally double up material during assembly. Our sound-deadening planning guide explains the questions to resolve before adding layers.
Check the cab as a whole
Test the carpet's position across the tunnel and both footwells before committing to cuts. Treat this as a sequence of checkpoints: driver's side, passenger's side, seat area and rear edge. Recheck the opposite side after moving the material. If an edge seems short, investigate alignment and application before trimming elsewhere.
For a practical manufacturer example, ACC's tutorial page includes a 1993 GMC truck carpet installation. Use that example alongside the instructions supplied with your own kit; it is not a promise that another truck uses identical mounting points or cuts.
Resolve shifters and accessories carefully
Locate the actual shifter or bracket before marking an opening. Do not cut with wiring, boots or other components directly behind the blade. Work with the minimum opening needed to continue checking the fit, then assess coverage with the relevant trim positioned in place.
After fitting, reinstall components according to the truck's service information. Check seat adjustment and pedal clearance, and make sure loose carpet cannot bunch beneath the pedals. Take final photos before returning mats and tools to the cab.
Planning an older Chevrolet project? Read our old Chevy truck carpet fit guide. Manufacturer reference: ACC installation instructions and truck tutorial.